I have a 1990 bmw e30 320i and at the rear vyew mirror i have like a led check panel.? - bmw led mirror
reviewed in the light of progress Ligths Flashig, but the brakes are working How can I prevent this.
Sunday, February 14, 2010
Bmw Led Mirror I Have A 1990 Bmw E30 320i And At The Rear Vyew Mirror I Have Like A Led Check Panel.?
4 comments:
It will blink on the dash and the LED lighting panel so far. It is assumed that disappears when you press the brake. It is his way of proving whether it works. If STEAP on the brakes and is always there. Make sure that the lights right there, because it is a benefit of more or less on your computer. If all goes well and the lights still do not.
These products R3Vlimited.
That's what we do first: go buy a can of CRC Electrical cleaner "and maybe some Q-tips and a good draft for a new bar. Sctochbrite Maybe a little red and some of the **** you spray the battery to prevent corrosion (not that BMW) use ****, if you want to see if you make a good connection over 15 years to stay.
Now find the "tail lights relay check" is a small black box about 3 "X 2" X 4 "with the son to leave their *** end. In the same panel that the antenna and ThE amplifier, left AKA root. TWO unlocked and lights, pull all 3 and placed on a desk or something, and Mom or bored with the kitchen table.
Now take a look at the connectors on the car. Spray them largely on the Convention. Use Qtips, Scotch Brite, whatever the hell that rub AVE connections in the plug ... Spray again ... will all be nice and clean and bright. I think I used a toothbrush on mine.
Check cleaning of the relay to the rear lights is very simple, so you rub the contacts with an eraser, a shower with the CRC. It aesily cleaning.
Well, its rear lights. Take the support before the lens, and if you want "does not deal with this stupid light panel to check again" (like me at school), the bulbs one by one, and brush the hole with Scotch Brite CRC and hybrids, which the new look. Be sure to clean the apartment where he focused on the ground, also ... Counsel mothers as a whole, make it perfect.
Now, car assembly, with or without new light bulbs ... Clean the onions, if you reuse,though. While assembling, make sure that you do not (the correct light bulbs 1157). Make sure that each connection is nice and tight. You can use a selection tool made of metal used (in which every person on this forum the producers) should make stronger links to ... whatever ... just make sure that each connection is tight.
His "CHECK" light should illuminate when the key off. Once you turn on the brake to the light, if no other issues.
If the flashing light continues to blink after leaving
or is put into service only during startup?
Check the device on older cars tend to brake at the beginning of the procedure to light (which is normal, because it just try to put this element) control. According to step on the brakes and removed, the light disappears.
And his statement is very clear. You do not mention that the flashing lights around the brake lights that appropriate to say that they work.
Clean the lamp made from any rust. Use lamps with stainless steel legs, not the things of bronze. These lamps can still, but the path to ground is low, and more like an open circuit in the computer.
"Make sure the correct bulbs (not 1157)"
Dont you mean 1156, not one since 1157 because the travel advice!
Post a Comment